Landing Gear Indicator Lights
100302-00
The following should be used to test and check the landing gear indicator lights.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Wing Jack Point Adapter—ICA009750
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
None
This task can be readily combined with the Landing Gear Retraction and Extension Time task. (Retraction and Extension Time)
Figure 300. Landing gear indicator.
Task Instructions
1. Verify Key Switch is in OFF position.
2. Follow jacking procedure to lift the aircraft off the ground. (796 Empty
Weight and CG Measurement While on Jackpoint Scales)
3. Move Master Switch to ON position.
4. Verify icon 3 (see illustration) is lit.
5. Move Landing Gear Lever to UP position.
6. Verify icon 2 (see illustration) is lit while the landing gear retracts.
7. Verify icon 1 (see illustration) is lit after the landing gear finishes retracting.
8. Extend gear, bring aircraft to ground, and remove jacks.
Verification Method
If each of the three lights indicated properly at DOWN, UP, and in transit when commanded, then the check is successful.
Parent topic